Aem 30-3305 V2 Water Methanol Multi Input Controller K Instrukcja Użytkownika Pobierz pdf (Strona 4)

Page 4

Controller Install

The progressive controller is NOT waterproof and should NOT be mounted in the engine bay!

Find a convenient location for the controller inside the driver’s compartment. The adjustment

knobs should remain in an accessible location but still remain protected from possible water

incursion. If you need to extend the wires to mount the controller use at least 16 AWG wire for

the pump and controller ground circuits and 18 AWG for the remainder. The controller contains

an externally accessible fuse, no additional fuses are required. Use the supplied zip-ties to

mount the controller.

Progressive Controller Installation

Pin #

Description

Wire**

Color

Connection

Pump Ground

AWG

Orange

Connect to ground (black) wire of pump.

LED -

AWG

Gray

Connect to ground (black) wire of external LED.

LED +

AWG

Violet

Connect to positive (red) wire of external LED.

Solenoid -

AWG

Brown/White

1.5A Low Side output. Connect to optional flow control

solenoid.

Boost Safe LS Out

AWG

Green

1.7A Low Side output. Grounded when error condition exists.

Pump Power

AWG

Pink

Connect to the positive (red) wire of pump.

Ground

AWG

Black

Main ground connection, connect directly to battery ground.

Level Switch+

AWG

White

Connect to the white wire of the fluid tank level sensor*

Level Switch-

AWG

Brown

Connect to the black wire of the fluid tank level sensor*

Arm Switch +

AWG

Yellow

Arms injection system. Connect to a switched 12V source.

External Signal

AWG

Blue

Connect to External Signal. (0-5V, injector duty, MAF

frequency)

Power 12V

AWG

Red

Main Power Connection, connect directly to positive battery

terminal.

*Note: If fluid tank is equipped with previous generation level sensor, identified by having two black wires, then

pins 8 (white) and 9 (brown) may be connected to either of the two black sensor wires. The polarity is

unimportant.

**Note: If you need to extend the wires to mount the controller use at least 16 AWG wire for the pump and

controller ground circuits and 18 AWG for the remainder.

External LED Install

Find a suitable location in the driver’s line of sight to mount the external LED. Mount the LED

and run the wires to the controller. The LED indicates the operation of the controller. If the

pump is off and there are no errors the LED will be off. If there are no errors and the pump is on

the LED intensity will vary with the pump speed. If there are any errors they will be indicated by

flashing the LED.

1 2 3 4 5 6 7 8 9 10 11

Komentarze do niniejszej Instrukcji

Brak uwag

Aem 30-3305 V2 Water Methanol Multi Input Controller K Instrukcja Użytkownika Strona 4

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Do samochodu Aem 30-3305 V2 Water Methanol Multi Input Controller K